Oxygen Panel

 Strategies
Kit Bashing
All plates need to be trimmed a little to allow easier fitting.

Backplate
Width5.75" (approx 146.05 mm)
Height8 DZUS units (8 x 0.375")
3.00" (approx 76.2 mm)
Backplate Thickness1/16"
Light Plate Thickness1/4" (0.25")
Module Depth?????????????????????

Simulator Supplier Parts
Hispa Panels145 x 76 mm
Sismo Solucionesdimensions not listed
CockpitSimPartsdimensions not found


December 2016 prices
Supplierpanelmeterannunpartstotalnotes
Hispa Panels 4014incl559 €
Sismo Soluciones-Module 5955inclincl114 €Assembled
Sismo Soluciones-Panel 20--20 €Front Plate Only
Open Cockpits219inclincl????? €Entire Aft Panel only
CockpitSimParts 2535incl~ 6£ 66
PC Flights Panel Not Found
STRATEGIES
The Problem :
The bolts holding the front and rear panels together interfere with the mounting rails. The left meter mounting tab is also in the mounting rail area.

The challenge is to make the unit fit between the rails.
The photos below show the panel build as supplied by Hispa Panels.

Post Script files for the circuit board

Circuit Board
Circuit Board Mirrored

  • Get 4 DZUS replica bolts (PC Flights and Sismo both supply them).
  • Trim the left side of the meter faceplate.
  • Glue front and rear acrylic plates together and cut to fit around the meter, switch and annunciator. (See Sismo Soluciones version).
  • The acrylic plate will have to be shifted left a little to miss the DZUS screw heads.
  • Make an aluminum mounting plate to mount everything. Include openings for the backlights.
    KIT BASHING
    Fabricate this plate