Bandwidth : DC to 25 MHz
Attenuation : 100X
Input Resistance : 10 MΩ
Input Capacitance : approx. 2.2pF (6 ft. cable)
Scope Input Resis : 1 MΩ
Compensation Range : 15pF to 55pF
Readout Pin : No
Ground Ref : No
ID Button : No
Max Rated Voltage : 1.5 KV RMS
| 
|
Various catalogs list using P6007 with:
5A14N, 5A15N, 5A18N
SC501, SC502, SC503
This list is based on the best match of probe bandwidth and scope/plug-in bandwidth.
The P6007 is a low input-capacitance, high-voltage passive probe with a signal attenuation of 100X.
It is designed for oscilloscopes having an input resistance of 1-megohm and input capacitance of 15 to 55 pf.
The P6007 consists of a probe-body assembly and a 3.5, 6, 9 or 12-foot cable.
Compensation is accomplished by turning the probe body and tip assembly while holding the knurled
section at the base of the probe. There is no separate compensating box with this probe.
(above excerpt from Tektronix® Products Instruction Manual 070-7839-06)
| Attenuation: | 100X, ±3% |
| Input Resistance | 10 megohms, ±2% |
| Input Capacitance | @2.0 pf (3.5 ft cable)
@2.2 pf (6 ft cable)
@2.4 pf (9 ft cable)
@2.6 pf (12 ft cable) |
|
| Maximum Voltage Rating | 1.5 kv dc or rms (2.1 kv peak or 4.2 kv peak-to-peak). maximum voltage must be derated at higher frequencies.
| | Environmental Capacitance | The 9.9 megohm resistor has been factory adjusted in the probe body for the best transient response. |
| Operating Temperature | The probe will operate normally at temperatures up to 75°C |
|
(above excerpt from Tektronix® Products Instruction Manual 070-7839-06)
| Tektronix Catalog Cost | Low Bid | High Bid | average |
|---|
$26 (1969)
$35 (1973)
$72 (1977)
|
$95 (1982)
$110 (1985)
$130 (1989)
|
|
. | . | . |
$15.00 8/6/01 #1622209312 outback6
$15.00 8/13/01 #1624643446 outback6
$15.50 8/15/01 #1625325102 booksabill
|
|